:	May 10, 2004

: Brake fluid will damage paint finished surfaces. If spilled, immediately remove the fluid and clean the area with water.

.

Remove the driver side closing trim panel.   Release the clip.   Remove the 2 screws.   Disconnect the electrical connector.

.

Release the clutch master cylinder clevis pin.   Remove the clip.

.

Remove clutch pedal spring assister.

.

: Before disconnecting or removing the components, ensure the area around the joint faces and connections are clean. Plug open connections to prevent contamination. Release the clutch master cylinder.   Position a container to collect the fluid.   Disconnect the electrical connector.   Remove the 2 bolts.   Remove the clip.

.

Remove the clutch master cylinder.   Disconnect the fluid supply line and discard the O-ring seal.

.

Install the clutch master cylinder.   Using a new seal, connect the fluid supply line.   Install the clip.   Tighten the bolts to 10 Nm (7 lb.ft).   Connect the electrical connector.   Remove the container.

.

Install the clutch pedal spring assister.

.

Secure the clevis pin.   Fit the clip.

.

Install the closing trim panel.   Connect the electrical connector.   Secure the clip.   Tighten the screws.

.

Raise and support the vehicle.

.

Bleed the clutch system.